Download validity fingerprint driver

When it comes to applying this package, please note that, although other platforms might also be compatible, it is not recommended that you to install the fingerprint software on OSes other than the specified ones; in other words, you have to make sure that your computer is supported by this release.

Once that out of the way, get the software, run the available setup, and follow the instructions displayed on-screen for a complete installation.

At the end, it's best that you perform a system reboot to make sure that all changes take effect properly. Click the download button now and set up this feature on your system. Driver Easy takes care of everything.

But with the Pro version it takes just 2 clicks and you get full support and a day money back guarantee :. Driver Easy uses only genuine drivers , straight from your hardware manufacturer. Or both. Hopefully you find this post useful. Please feel free to leave a comment below if you have any further questions or ideas.

Thanks for reading! Note, I did not have to uninstall the old driver or remove the device from Device Manager. Worked like a charm. See the last post on the link below:. Today I had the exact same experience on Windows 8.

After that I tried it with v. It's no more necessary to uncheck "allow the computer to turn off this device to save power". I hope the following solution also works with Windows Didn't find what you were looking for? Ask the community. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Showing results for. Search instead for. Did you mean:. Then return here to continue. Install the sensor driver. There are four main methods for installing a driver on the Sharks Cove board: Download the driver from a network source directly onto the Sharks Cove.

Develop the sensor driver on a host computer, with your Sharks Cove connected as a provisioned client. Then deploy the driver from the host computer to the Sharks Cove. The accelerometer is attached to the Sharks Cove via the I2C bus.

This table describes the hardware resources and interrupt requirements for a hardware platform's devices, including attached peripherals like the accelerometer. Before you start performing the tasks outlined below, please make sure that your Sharks Cove is set up as shown in the following image:.

You will also learn how to replace the default SSDT with an updated one. On the Sharks Cove, create a Tools folder in the root directory. Open a Command prompt window as an administrator, and enter the following commands: cdtools dir Make sure that the Asl. Make sure that the ASL file was created successfully by entering the following command: dir ssdt. Open the ASL file in Notepad by entering the following command: notepad ssdt.